BIGTREETECH Tango V1.0 Motherboard Upgrade on Rumba MPU / Optimized For 3D Printer

SKU: ZZB000185

$36.90

Shipping calculated at checkout

Tango 1.0
Tango +A4988*6
Tango +DR8825*6
NOTIFY ME WHEN IN STOCK
Brand Name:Ā BIQU
Product Name:Ā BIQU Tango V1.0
Type:Ā Motherboard
Input voltage:Ā 12V-24V
Condition:Ā New 100%
Lead Time:Ā In stock


  • Introduction

ElectronicĀ partĀ is the brain of a 3D printer, and all movements are controlledĀ by electronicĀ parts. The Tango1.0Ā baord is R&D for 3D Printer,which isĀ Based on AVR Processor ATMEGA2560Ā controller board.It support three different color filament, You can use a personal computerĀ with a USB cable to control the 3D printer

1.There are six stepper motorand five temperature sensor input interfaces;

2.LCD expansion interface,supportLCD screen and SD expansion interface, it can achieve offline printing;

3.UsingATMEGA2560 as the main control chip, with high-performance USB to UART chip CP2102,it is compatible toall related RAMPSĀ firmware;

4, Power input is 12-24V, the rated voltage of the hot bed is same as the input voltage of the power supply, the voltage ofĀ the hot bed will be 12v if the voltage of power supply is 12v,and the voltage ofĀ the hot bed will be 24v if the voltage of power supply is 24v.

5,.PWM DC output (heating rods, fans, etc.); 6 outputs (1 large current, 3 medium currents, 2 small currents), driven by high performance, low on-resistance MOS transistors, Ā LED as an indicatorĀ forĀ each output.

Ā 

Notice :

AboutĀ Ā DR8825Ā  driver :The reference voltage Vref must be less than 1.25V.

We have white and yellow inserts for the main board, and we send them at random when delivered.(Just the color different .)

1.It is necessary to distinguish the positive and negative electrodes When connecting the power supply
2ļ¼ŒPlease pay attention to the type of driver you have purchased and install it correctly.
3ļ¼ŒThis 3D printer motherboard has a large current, high temperature characteristics, must pay attention to fire prevention, protection! Do not place this motherboard next to flammable objects;
4ļ¼ŒThe temperature of the circuit board will rise sharply when the hot bed is heated. If the printer is in a bad position of air circulation, the circuit board fuse will be automatically disconnected because of the high temperature, and the hot bed cannot be heated;
5ļ¼ŒIf you use mechanical switches as limited switches, just need to connect "signal S" and "ground-wire" terminals, and the "power supply +" terminal does not need to be connected.If it wrongly connect the mechanical stop switch to the circuit board. The power +ā€ and ā€œground ā€“ā€ terminals will burn the board.



Open source

https://github.com/bigtreetech/Tango
http://certificate.oshwa.org/certification-directory/



The more details files you can download :Ā 

https://github.com/bigtreetech/Tango


TheĀ operate video can refer to check :

https://www.youtube.com/watch?v=91lT95ZZ_rE

Ā 



Ā 

Ā