BIGTREETECH Octopus Pro V1.0 Control Board/ Mainboard
Firmware link: Click here
【Main Control Chip】The main control board uses 32-bit ARM-level Cortex-M4 series STM32H723ZE/ STM32F429ZE / STM32F446ZE chip with a frequency of up to 168MHz and the flash is 1MB.
【Support 60V Input】Supports up to 8 3D printer motherboards with a maximum 60V stepper motor. The motor drive power supply supports up to 60V input (only for the motor drive power supply).
【6 Controllable Fans】Up to 6 controllable fans, two normally open fans, and both support power supply voltage, 12V, 5V options.
【Update Firmware: Klipper/Marlin/RRF】Supports firmware update via DFU mode. This is where the firmware is sent to the board directly from the PC and does not require a bootloader however this method is not recommended for novice users as discussed later in this document.
【Level conversion IC】Supports proximity sensor, jumper optional pull-up resistor, supports more models, supports BL Touch.
This is the third album from BTT. I already have a 1.3 and 1.4 TURBO board. So far, the album is performing positively. It has what previous BTT models lacked.
BIGTREETECH BTT Octopus Pro V1.0 for 3D Printer
Octopus pro very nice board good quality
All ordered items received in good shape.
The double pulley mk8 was not the type I had ordered, the one I received had a single pneumatic joint and I ordered one with dual pneumatic joint.
Now to find the time to get everything installed.
The Board ist working good, perfekt for Corona 2.4 but the documentation for CAN could bei better