Nota:
1. Se requiere [Conector EZ-Driver] si utiliza el controlador EZ (como EZ2209 / EZ5160 Pro) para la placa de control SKR 3.
2. El chip se actualizó a H723, que tiene una frecuencia de actualización más rápida (hasta 550 MHZ).
Customer Reviews
Bit of a head mess for me to get it setup, but once I was on the right path, haven't looked back, printer is working way hard than it was intended too and loving it!
Most people might think its a bit of a waste, but I ordered an upgraded Anet A8 Plus. Upgraded that as well and that was a solid platform for the motherboard and driver upgrade. What a difference, its all so quiet now.
BIGTREETECH BTT SKR 3 Control Board for 3D printer
awesome board. controls my printer fantastically
I've spent a considerable amount of time and money upgrading my old Anycubic i3 so when the second original Tri-Gorilla board popped the DC regulator it was time for an upgrade. SKR3 ordered with EZ drivers and TFT and was with me in no timer.
After a steep learning curve with Marlin compiling, my old i3 was alive now with RGB heat indicators, BLTouch levelling, a new colour TFT display and all the benefits of not using a five year old borderline stock firmware.
However I had a few weird power off issues when trying to print which finally culminated in the printer refusing to boot. After some digging it appeared that the printer PSU was at fault and had finally failed delivering only 5v when loaded. Thankfully the SKR3 didn't seem troubled by the PSU and booted up as soon as a new PSU was installed.
I would imagine the PSU fault killed the first two boards but the SKR3 took it in it's stride. Overall a huge improvement on what I had and overall a great performing board.
BIGTREETECH BTT SKR 3 Control Board for 3D printer
