BIGTREETECH Octopus V1.1 Control Board for Voron 2.4

SKU: 1020000286

$49.99 $69.88 Save $19.89

Shipping calculated at checkout

Without drivers
With 6 PCs TMC2209
With 8 PCs TMC2209
NOTIFY ME WHEN IN STOCK
2022 09 06t114842

Global shipping

180-days warranty

7-days refund

Octopus V1.1 Control Board / Mainboard

  • 🐙【Main Control Chip】Uses a 32-bit ARM Cortex-M4 series STM32F446ZET6 main control chip with a core frequency of 180MHz.
  • 🐙【Strong DIY Support】This motherboard supports up to 8 stepper drivers with 9 stepper driver outputs in total; And up to 6 PWM fans and 2 always-on fans with the ability to individually select the voltage rail that will drive each fan. Select from Vin, 12V or 5V.
  • 🐙【Motherboard Expansion Function】Support BLTouch, locked-rotor detection, shut down after printing, resume printing after power failure, CAN bus, U disk function, IIC expansion; at the same time reserved WIFI interface, PT100 thermistor interface (optional), dual Z-axis printer.
  • 🐙【TMC2209 Driver Features】The TMC2209 stepper driver is not easy to lose steps and is in an ultra-quiet mode; the module has a large area of heat dissipation pad, which can reduce the temperature of the driver when it is working; the module supports three modes: STEP / DIR and UART.
  • 🐙【TMC2209 Driver Mode】TMC Motor drivers can be used in SPI or UART mode by simply adjusting the onboard jumpers beneath each motor driver. Additionally, you can connect or disconnect the TMC DIAG pin using an onboard jumper allowing you to use hard end-stops or sensorless homing without the need to cut any pins.

Customer Reviews

Based on 1 review
0%
(0)
100%
(1)
0%
(0)
0%
(0)
0%
(0)
T
Ted
Good, but fragile.

I only received this parcel today, after 14 days. I bought this as a replacement since I lost the serial port on a previous board. (Not the first time a port goes.)
BTT boards are very good, easy firmware updates.
Good setup info like buffer sizes and other advanced settings that are board specific for Marlin is to my knowledge, non-existing.
It would be great if BTT can publish some professional optimized setting for their boards.

Thanks for your feedback, we will keep creating better products!