ADXL345/S2DW Accelerometer Board for Running Klipper

I did input shaping with this sensor on my RatRig V-Minion. Flawless indeed! Just attach to Control board pins, bolt unit onto relevant axis, push button on KlipperScreen and save configuration. Noticeable print quality improvement even BondTech extruder does a perfect job without calibration too.

One of the easiest things I've installed and used on my printer

This was a great add-on for my Klipper upgrade. The ADXL345 made input shaping easy and trouble free as I did not have to print parts and use a caliper to measure where the best print quality was. You connect the circuit board to the printer's motherboard or PI, connect it to the X axis and run the command and save the config when done. Repeat for the Y axis and you are done. Literally it is that easy.

I have come to trust BTT and will be using their products for upgrades to my two other printers as well.

I can not recommend this company strongly enough.

Good

No Instructions as every use is different, Klipper had plenty of instructions and it worked perfectly. Great prints!