BIGTREETECH ERCF Control Board MMB CAN V2.0 with STM32 Chip Featured EZ Ports for 3D Printer Enraged Rabbit Carrot Feeder Solution

Used one on a TradRack and it works flawlessly. Ordered another for a Happ Turtle Lettuce Feeder. The amount of extra endstop ports should work well for it.

My only criticism is that, unlike all the other BTT boards, this one does not come with a pouch of connectors and pins. Particularly the 14 pin Microfit connector for the extra ports.

It was easy to set up, has a lot of ports for sensors, and the ez-driver slots are nice too. It was worth the price.

Perfect

Board arrived a little earlier than expected. It was packaged well and the duck unharmed. The board fired up and sis as desired. The documentation on GitHub is good.

This board works great. I haven't had a single issue with it since getting it up and running. That said, here are two things I would have liked to know before purchasing:
- Flash CanBoot, even if you don't use CAN
- The EZ drivers are tall, which is important if you design your own enclosure